ETAS MDA V8.6 User Manual page 91

ETAS
To use common axes
To see how you can modify in an oscilloscope signal and axes settings, watch
our video
As long as the data type of signals fits, several signals can share the same
value axis. To use common axes:
To use individual axes
If several signals share the same axis, the signals can be assigned to individual
axes again.
MDA V8.6 – User Guide
One common axis for all signals
Assign all signals to one axis.
Shared axis per unit
Assign signals to an axis having the same unit.
Individual axes per signal
Assign each signal to an individual axis.
Take-over axis assignment
Take over axis assignment of source oscilloscope.
(Option is only provided if the signals derive from an exist-
ing oscilloscope.)
New strip
Create a new strip below the current strip.
The selection wheel expands to the above described
options, and the signals will be assigned to a new strip
using the chosen option.
Note that an axis can be shared only for matching data types and
the same data representation. "No-Match" signals get an own
axis, as the original unit is not known.
Boolean and Event signals will be assigned to the corresponding
strips independently from the drop position.
Oscilloscope - Settings for Signal and Axes.
1. While pressing the C
in the signal list.
2. Right-click your selection and click Use common axes.
Alternatively, drag and drop the desired signals on one axis. Note
that the signal is only added to this axis if it has same data rep-
resentation.
1. Do one of the following:
Right-click the shared axis.
Right-click the desired signal(s) in the signal list.
2. Click Use Individual Axes.
or S key, select your desired signals
TRL HIFT
5 Instruments
91