ETAS MDA V8.6 User Manual page 89

ETAS
To add another strip
To reorder strips
To move analog signals to a common or individual strip
To use the selection wheel for this operation, see "To assign signals using the
selection wheel" on the next page.
Alternatively, use the context menu as follows:
MDA V8.6 – User Guide
1. Open the context menu of an existing strip.
2. Select Add Strip.
Depending from the strip the action was triggered, an analog or a
Boolean strip is added. The new strip is displayed below the cur-
rent strip.
This is not the case for the Event strip, as only one Event strip is
available for all events.
When you add signals to the oscilloscope, the selection wheel
appears, which allows to create a new strip for the signals. For
more information, see "To assign signals using the selection
wheel" on the next page.
1. Click on the strip.
A blue bar occurs on the left and right edge of the strip.
2. To move the selected strip, do one of the following:
To move the strip up, press A
To move the strip down, press A
or
Click on one of those bars and pull it up or down to the desired
position.
The new position of the floating strip is indicated by a small
blue rectangle.
This action is not possible for the Event strip, as there is only one
event strip always located at the bottom of the strip area.
5 Instruments
+P U .
LT AGE P
+P D .
LT AGE OWN
89