ETAS MDA V8.6 User Manual page 30

ETAS
To use the "Add or Replace Files" dialog
To replace a measure file
To see how you can replace a measure file, watch our video
Measure Files.
To resolve the "No-Match" situation, see "To replace a signal" on page 53.
MDA V8.6 – User Guide
that allows you to either add or replace the selected measure
files. For more information, see "To use the "Add or Replace
Files" dialog" below.
1. The dialog opens if the following prerequisites are fulfilled:
Measure files have been removed earlier. The configuration
thus contains "No-Match" signals.
You have performed the steps described in "To add a measure
file" on the previous page.
In the table, all newly selected measure files are displayed in
the first column. In the second column, all removed measure
files from which there are still some signals in use ("No-Match"
signals) are displayed. If available, all used measure files are
also displayed in the second column.
2. To replace a missing or used measure file, drag and drop a newly
added file from the first column onto the row of a file in the
second column.
The file is moved from the first column into the third column that
displays all replaced files.
3. To undo the replacement, click the undo icon on the right side of
the replaced file.
The cell is cleared and the file is added to the list in the first
column again.
4. Click Ok.
All measure files in the first column are added and all measure
files in the third column replace the ones in the second column.
1. Do one of the following:
In the File Explorer, select a single measure file. On the Con-
figuration tab of the ribbon, click
In the File Explorer, hover the cursor over a measure file and
click .
Right-click a measure file and select Replace Measure File.
2. Select the new measure file in your file system.
2 Configuration Creation
Replacing
.
30