Table of Contents
Advertisement
ETAS
1.4.2
Connecting MDA to EHANDBOOK-NAVIGATOR
To analyze system behaviors, you can combine the measure data displayed in
MDA V8.6 with the description of the ECU functionality as provided in
EHANDBOOK-NAVIGATOR.
You can perform the following actions:
"To connect to EHANDBOOK-NAVIGATOR" below
l
"To disconnect from EHANDBOOK-NAVIGATOR" on the next page
l
"To send the cursor time to EHANDBOOK-NAVIGATOR" on page 99
l
"To pass the signal name to EHANDBOOK-NAVIGATOR" on page 56
l
To connect to EHANDBOOK-NAVIGATOR
To establish a connection, MDA V8.6 and EHANDBOOK-NAVIGATOR (V6.1 or
higher) must be installed on the same machine.
MDA V8.6 – User Guide
3. Perform your analysis in MDA V8.6.
4. With INCA V7.2.14 (or higher) and MDA V8.3.3 (or higher), if MDA
is already open, and exactly one measure file is assigned to the
active configuration, a measure file replacement will take place.
In case more than one file is assigned to the active configuration,
a dialog appears to decide for an add or a replace operation. For
more information, see "To use the "Add or Replace Files" dialog"
on page 30.
If INCA provides besides the measure file also an XDA file, and
MDA V8 has no or only an empty configuration, MDA V8 imports
the XDA file and the measure file from INCA.
1. Click
.
2. Select a EHANDBOOK file.
3. Select a measure file.
All measure files are listed that are currently in the active con-
figuration. You can synchronize only one measure file at a time.
4. Click Connect.
The connection is established. In the File Explorer, the selected
measure file is marked as synchronized.
You can also connect MDA V8.6 to a running EHANDBOOK-
NAVIGATOR session. This requires EHANDBOOK-NAVIGATOR
V8.0 or higher.
If you replace the synchronized measure file in the MDA con-
figuration, EHANDBOOK-NAVIGATOR is automatically informed.
If you remove the synchronized measure file in the configuration,
the connection to EHANDBOOK-NAVIGATOR is disconnected.
1 Welcome to MDA V8
21
Advertisement
Table of Contents
