ETAS MDA V8.6 User Manual page 116

ETAS
To add an Event signal
When adding event signals to a GPS map, the location where an event
occurred is indicated by
If several tracks are displayed, for a unique identification the color of the icon
has the same color as the track. The color of the flash inside the icon rep-
resents the event type (e.g. pause event, comment event, calibration activity,
etc.).
To zoom
Do one of the following:
To zoom to show the complete track
To select a specific time range of the track
To show cursors
In synchronized mode, cursors are shown as these are given by the master
instrument. Cursors can be moved directly in the GPS Map instrument or fol-
low the cursor's movement in the master instrument.
To remove a signal
MDA V8.6 – User Guide
.
1. To zoom in, click
2. To zoom out, click
or
1. Use the mouse wheel to zoom in or out.
1. Click , and the map will be zoomed that the track is completely
visible.
1. To see which track was driven during a specific time range, the
Time Slider is used. For more information, see "Time Navigation
and Synchronization" on page 118.
When only a sub-time range is selected, this track is shown in
dark blue, while the track outside this time range is indicated in
light blue.
Open the Configuration Manager and remove the respective sig-
l
nal from the GPS Map view.
or
In the GPS Map instrument, right-click the signal and select
l
Remove Track(s).
or
In the GPS Map instrument, click the signal and press the Del key.
l
.
.
5 Instruments
116