Table of Contents
Advertisement
ETAS
Note
Per signal only one rule set is applied.
The rule set affects the Display Name only, but not the Name, Display Iden-
tifier, or Symbol Link as shown in the Variable Explorer or Information Win-
dow.
For more information about what is displayed from the variable name, see
"Defining Display Name in the Application" on page 45.
You can perform the following actions:
"To add a rule set" below
l
"To define the affected variables" on the next page
l
"To adapt the example for testing the rule set" on the next page
l
"To reorder rules within the rule set" on the next page
l
"To reorder rule sets within the Rule Sequence" on the next page
l
"To delete a rule set" on page 41
l
To add a rule set
MDA V8.6 – User Guide
1. To add a rule set, click the
2. Assign a name to the rule set.
By default the name is set to "Rule Set". If the name is already in
use, it is extended by an increasing number.
3. To add a new rule, click the
A new rule block appears.
4. Select the direction from which the variable name shall be inter-
preted when applying the present rule.
5. Select in Action which segment of the variable name shall be hid-
den respectively remain visible.
6. Define the Separator, e.g. a dot, underscore, slash, or similar,
which shall be used for segmentation of the variable name.
It is also possible to enter letters or numbers. You can use a
single character or a string.
7. The Number defines how often the separator must appear until
the action is applied.
The selected direction applies.
8. Select the checkbox Trim leading and trailing to remove from
the beginning and from the end respectively the undesired sep-
arators.
9. Click Save to store the complete rule set defined by the individual
rules and the group of variables to be effected.
2 Configuration Creation
icon in the Rule Sequence toolbar.
icon under Define rules.
39
Advertisement
Table of Contents
