ETAS MDA V8.6 User Manual page 110

ETAS
To change the number of decimals
To change the data representation of a signal
To remove signals
MDA V8.6 – User Guide
1. Mark the columns for which you want to change the number of
decimal places.
2. In the toolbar, click one of the following icons:
To show more decimal places, click
To show fewer decimal places, click
The decimals for the time values can be adapted in the same
manner.
1. In the table, select one or more signals.
2. In the toolbar, click
3. Select one of the following entries from the Data Representation
drop-down menu:
Physical Values
Hexadecimal (memory) Values
Binary (memory) Values
Decimal (RAW) Values
All selected signal values are shown in the selected data rep-
resentation. The unit information is adapted according to the
selected data representation.
Note that if the device name of the signal ends with
#MeasureCal, you must additionally select which data type shall
be used to display the values. Select one of the following:
8 bit
16 bit
32 bit
Do not cast
In this case, the shown hexadecimal or binary representation
for the Float value is according to the IEEE-754 standard.
1. Select one or more signals. Do one of the following:
In the instrument, mark one or more columns.
In the Configuration Manager, mark one or more signals.
2. In the context menu, select Remove.
.
.
.
5 Instruments
110