ETAS MDA V8.6 User Manual page 52

ETAS
To assign signals to an existing instrument
To move or copy signals from one instrument to another instrument
MDA V8.6 – User Guide
3. Select the instrument type that you want to create.
On the layer, the new instrument is displayed in the foreground
and highlighted. In the Configuration Manager, the name of this
instrument is displayed in bold.
In the Variable Explorer, you can identify all signals that are
assigned to an instrument in the Used column. For more inform-
ation, see "To filter used/unused signals" on page 49.
1. In the Variable Explorer, press the C
signals that you want to use for analysis.
2. Using the mouse:
i. Drag and drop the selected signals to an existing instrument in
the configuration or to the respective entry in the Con-
figuration Manager.
3. Using the keyboard:
i. In the instrument, press the I
A pop-up appears.
ii. Type at least one letter of the signal name.
A list of signals appears.
The next time the pop-up appears, it displays the previously
selected signal name in a marked state.
iii. To move to the desired signal, use the A
D key.
OWN
iv. To add a single signal to the instrument, press E
or
To add several signals to the instrument, press the S
and continue to select or search.
1. In the instrument from where you want to move or copy the sig-
nals, select the signals.
2. Do one of the following:
To move the signals, drag the selected signals and drop them
onto another instrument.
To copy the signals press the C
the selected signals onto another instrument.
The same operations are also supported in the Configuration
Manager.
3 Signal Selection
or S key and mark all
TRL HIFT
key.
NSERT
U or A
RROW P
NTER
key first before dropping
TRL
RROW
.
key
PACE
52