Using Strips - ETAS MDA V8.6 User Manual

ETAS
To show the full time range
If the time range is not completely displayed in the oscilloscope, the time axes
can be adapted to show the full time range.
To zoom to fit signals
If a signal is not completely displayed in the oscilloscope strip, the value axis
can be adapted to show the complete value range. Do one of the following:
5.2.4

Using Strips

The signals in the oscilloscope can be distributed onto analog and Boolean
strips for a better overview. After the signal selection, an analog strip, the
required number of Boolean strips, and optionally one event strip are added in
an oscilloscope corresponding to the selected signals.
MDA V8.6 – User Guide
If you zoom in deeply, sample markers are displayed. To change
the appearance of the sample markers, see "To define the appear-
ance of the signal" on page 99.
1. Click .
Alternatively, you can perform this operation by using the time
slider. For more information, see "To show the full time range of
the measure file" on page 123.
1. To adapt selected signals, right-click the signals in the signal list
or right-click one signal directly in the strip.
2. In the context menu, click Zoom to fit Signal(s).
or
1. To adapt all signals of a selected strip or value axis specifically,
right-click the strip or value axis.
2. In the context menu, click Zoom to fit Signal(s).
or
1. To adapt all signals in all strips, click
5 Instruments
.
87