Table of Contents
Advertisement
ETAS
2.2.3
Measure File Comment and Other Meta Information
For each measure file used in a configuration, you can display its metadata,
e.g. the file comment and information about when, by whom, and for which
project the file was created.
You can perform the following actions:
To display comment and other meta information
To edit comment and other meta information
MDA V8.6 – User Guide
are allowed.
To apply a time offset for individual signals, see "Defining Cal-
culated Signals" on page 58.
2. Click Apply.
For all signals from the same file, the samples are shifted accord-
ingly. The shifted data is also used for calculated signals. Note
that if you replace the measure file with another one, the defined
time offset remains still the same.
"To display comment and other meta information" below
l
"To edit comment and other meta information" below
l
1. Do one of the following:
In the File Explorer, hover the cursor over a measure file.
The metadata is displayed as a tooltip.
In the File Explorer, select the file and press C
The metadata is displayed in the Information Window. You
can select the content of the table and copy it to the clipboard.
2. If you select another measure file, the metadata is updated auto-
matically in the Information window.
1. In the File Explorer right click the measure file and select About
Measure File.
or
Press C
+I.
TRL
2. To edit the comment or meta information, click
You can edit the following fields:
User
Company
Vehicle
Project
Default and User Comment.
2 Configuration Creation
+I.
TRL
.
33
Advertisement
Table of Contents
