AGFA DR 800 User Manual page 252

252 | DR 800 | Options and accessories
1. Place the table in the vertical position.
2. Loosen the knob of the clamp as much as it is necessary, by turning it
counter clockwise.
3. Insert the clamp on the tabletop guide.
4. Place the lateral arm rest in the required position.
The lateral arm rest can be mounted anywhere on the side rails of the
tabletop on either side.
5. Fasten the clamp by turning the knob thoroughly clockwise.
6. Adjust the position of the lateral arm rest.
The lateral arm rest can be rotated to adjust it to the preferred height.
a) Loosen the round knob while supporting the lateral arm rest with your
b) Place the lateral arm rest in the required position.
c) Fix the position by turning the round knob thoroughly clockwise.
7. After usage, remove the lateral arm rest from the radiographic table.
Loosen the knob of the clamp by turning it counter-clockwise and slide the
lateral arm rest off the side rail of the tabletop.
0392C EN 20210309 1049
WARNING:
Check that the knob is fully screwed in and the attachment is
properly secured to the table rails. If not properly secured,
the accessory may fall, be damaged, and be dangerous for
people in the room.
other hand.
WARNING:
This adjustment should always be made with one hand
acting on the knob and the other hand holding the rod. The
rod has no mechanical stops, if not restrained, it may collide
with nearby objects or people.
WARNING:
Hold the accessory firmly to prevent it from falling.