AGFA DR 800 User Manual page 119

Figure 81: Positioning controls on the software console
b) Move to the selected automatic position.
Indicator light is blinking if an automatic position is selected, until
1.
the automatic movement has finished
Operate the joystick to move to the selected automatic position,
2.
while the indicator light is blinking
Figure 82: Position controls
The actual and target position parameters are displayed on the
software console. When the target position is reached, the movement
stops and the indicator light on the console goes out.
c) Adjust the position using the position controls.
4. Position the patient.
5. Acquire a set of fluo sequences, rapid sequences and static images.
Any number of fluo sequences, rapid sequences or static images can be
acquired, in any order.
Table 8: Supported workflows
Image type Settings Step 1: activate Step 2: start ex-
Fluorosco-
py
Rapid se-
quence
1 2
posure
not needed
fluoroscopy pedal
DR 800 | Basic Workflow | 119
Result
0392C EN 20210309 1049