Chrysler DODGE D150 1993 Service Manual page 441

8K - 10 WINDSHIELD WIPER AND WASHER SYSTEMS
•
(2) Mount multifunction switch to column and (4) Install tilt lever (tilt column only),
torque retaining screws to 2 N»m (17 in. lbs.). (5) Install battery cable.
(3) Install steering column covers. Torque retain- (6) Check all functions of switch for proper opera-
ing screws to 2 N»m (17 in. lbs.). tion.
WINDSHIELD WASHERS
GENERAL INFORMATION
All models are equipped with electric operated
windshield washer pumps.
The electric pump assembly is mounted directly to
the reservoir. A permanently lubricated sealed motor
is coupled to a rotor type pump. Fluid, gravity fed
from the reservoir, is forced by the pump through
rubber hoses to the nozzles which direct the streams
to the windshield.
These vehicles are equipped with special plastic
washer nozzles (Fig. 1). Because they are inserted di­
rectly into the cowl panel, there is no adjustment re­
quired.
Fig. 1 Windshield Washer System
WINDSHIELD WASHER PUMP REPLACEMENT (Fig.
2)
REMOVAL
(1) Remove liquid from reservoir.
(2) Remove reservoir mounting screws and remove
reservoir and pump assembly.
(3) Disconnect electrical lead and rubber hose from
bottom of pump.
(4) Using an extension and deep well socket, reach
through reservoir filler neck, and remove pump
mounting n u t and plastic washer.
(5) Remove pump from bottom reservoir.
(6) Remove rubber grommet from reservoir and
throw away.
Fig. 2 Washer Pump
INSTALLATION
(1) Install new rubber grommet into place in bot­
tom of reservoir.
(2) Position pump into place in reservoir. Install
plastic washer then mounting nut, and tighten to 3
N»m (25 in. lbs.) torque. Do not overtighten.
(3) Connect electrical leads and hose to pump.
(4) Position reservoir into place, install mounting
screws and tighten securely.
(5) Fill reservoir with water and/or washer fluid,
inspect for leaks and test system.