Chrysler DODGE D150 1993 Service Manual page 399

8E - 18 INSTRUMENT PANEL AND GAUGES —
•
Fig. 3 Overdrive Lockout Switch and Message
Center Module
J918E-32
Fig. 4 Message Center Printed Circuit
Board—Automatic Transmission
INSTALLATION
(1) Position lockout switch into module and push
until retaining tabs lock into place.
(2) Connect switch connector.
(3) Install instrument cluster bezel to panel.
MESSAGE CENTER MODULE (Fig. 3)
REMOVAL
(1) Remove map lamp.
(2) Remove cluster bezel (refer to Cluster Bezel Re­
moval).
(3) Reach behind bezel and disconnect lockout
switch (if equipped) and message center connectors.
(4) Remove 3 module retaining screws and one clip
and pull module from bezel.
(6) Install cluster bezel.
(7) Check operation of switch.
POWER MIRROR SWITCH
Refer to Group 8T - Power Mirrors
CARGO LAMP SWITCH
REMOVAL
(1) Locate chime module. Grasp chime module and
twist it to remove it from the bracket.
(2) Remove wiring connector from cargo lamp
switch.
(3) Depress lock tabs on switch and push it out of
the instrument panel.
INSTALLATION
(1) Hold wiring connector in switch opening.
(2) Push switch on to wiring connector.
(3) Continue to push until switch snaps into place.
(4) Install chime module on to bracket.
MAP LAMP SWITCH
REMOVAL
(1) Remove 2 attaching screws.
(2) Drop assembly down and remove wiring con­
nector, then remove map lamp assembly.
INSTALLATION
(1) Connect wiring connector to lamp assembly.
(2) Position map lamp assembly to panel and in­
stall 2 mounting screws.
GLOVE BOX LAMP SWITCH
REMOVAL
(1) Open glove box until stops in bin rest against
instrument panel.
(2) Depress stops to clear instrument panel and
continue pivoting glove box assembly downward.
(3) Disconnect wire to switch.
(4) Snap switch out of panel.
INSTALLATION
(1) Snap switch into panel.
(2) Connect wire to switch.
(3) Depress stops and close glove box door.
OVERDRIVE LOCKOUT SWITCH (FIG. 3)
REMOVAL
(1) Remove map lamp.
(2) Remove cluster bezel (refer to Cluster Bezel Re­
moval).
(3) Reach behind bezel and disconnect lockout
switch connector.
(4) Depress retaining tabs on top and bottom of
switch and pull switch out of module.