Veripos LD6 Operation Manual page 61

Use the Up/Down arrows to switch between LAN1 and LAN2.
The display shows the port name, current IP and current mode.
Note that in the illustration above, the IP is the current IP assigned by the DHCP server,
not the current setting of the static address (also known as the Fallback Address).
To change the current configuration, touch the Next button:
Use the Up/Down arrows to change the mode if required, then touch the Next button to
move to the next setting. It is necessary to cycle through all four pages in order to reach
the "Finish" button which is used to accept the changes.
The four pages allow the user to:
The factory LAN DEFAULT SETTINGS are as follows:
Mode: STATIC
LD6 (Version 8 & Version 50) Operations Manual
Set
Mode
Static Address
Subnet Mask
Gateway Address
Static IP (LAN1):
Static IP (LAN2):
Subnet Mask:
Gateway Address (LAN1):
Gateway Address (LAN2)
Description
Choose between Static or DHCP –
Veripos recommend use of Static
To Set Static / Fallback address
To set the Subnet Mask info
Where required – Use Finish button
to confirm changes.
192.168.002.002
192.168.003.003
255.255.255.000
192.168.002.001
192.168.003.001
LD6 Operation
60(85)