LD6 Operation
2.4 LD6 Start up
Confirm the LD6 has been correctly installed.
Where required refer to the LD6 Installation Manual and the Antenna & Coaxial
Cable Installation Guide.
These documents are provided with the unit or may be downloaded in .pdf format
from the VERIPOS online support system (VOSS) at:
https://help.veripos.com
Plug in power to the rear of the unit. Turn on power switch.
Wait a few minutes while a self-test is performed.
Following successful test you will see the main or home screen.
The LD6 is disabled when first started. Before a beam is selected and the unit is enabled
the L-Band icon will be red.
If there is a problem refer to the Troubleshooting chapter in this manual.
Figure 6 LD6 Main Screen
LD6 (Version 8 & Version 50) Operations Manual
16(85)