Veripos LD6 Operation Manual page 18

Key
1 LD6 Unit ID
S – L-Band beam Sync Green = yes, Red = not synced with beam
2
E – VERIPOS corrections Green = enabled Red = not enabled
3
4 L-Band signal strength indicator
5 Touch screen buttons to access L-Band card, GNSS card, optional MF (Beacon SBX
receiver) and UHF ADL cards, information and controls. Buttons provide access to each
receiver (as fitted).
6 LD6 time display (UTC)
7 Buttons in red indicates the cards have configuration or fault condition and are not
working to correct limits
Actions – Shut down, Log Off, Reboot, Factory Reset or LD6 Screen calibration of
8
screens 1 and 2, Launch Apps
Solutions – Status including current position, select the required PPP solution, config of
9
solution and NMEA output selection
Settings –Set up of position output ports, reference stations and network configuration
10
Figure 6 shows an enabled LD6 touch screen. Four of the six rear bays are equipped with
receiver cards. Two bays are for future use.
The home page of the LD6 touch screen displays the Unit ID number (top left).
The time is shown in Coordinated Universal Time (UTC), 24 hour format (top right).
Each of the four upper touch screen buttons correspond to a receiver or card housed in
bays accessed from the rear of the LD6. LD6 units may not have all cards fitted.
NOTE
Only when a receiver card is present a button is displayed on the touch screen
Configuration of each installed and working receiver card is done using the touch
screen front panel (Figure 3). Select the corresponding on screen button.
LD6 (Version 8 & Version 50) Operations Manual
LD6 Operation
17(85)