Veripos LD6 Operation Manual page 60

Touch Settings / Network / Status button to display the current settings of the ports:
The Up/Down arrows may be used to switch between LAN1 and LAN2.
Name: Identifies the port and status is shown in brackets:
Up
Down
Addr:
IP:
In Static mode, this is the static IP address assigned in Config
In DHCP mode, this is normally the IP address assigned by the external DHCP server.
a) If an IP is received from the server, it is displayed followed by "(auto)".
b) If no IP is received from the server, the unit falls back to the static IP.
The static IP is displayed followed by "(fallback)" [this is usually an indication of a fault]
Mode: Shows the mode selected in Config (either Static or DHCP)
2.11.4.3 Network / Config
From the LAN menu touch the Config button to open the configuration page:
LD6 (Version 8 & Version 50) Operations Manual
= Port connected
= Port disconnected
= MAC address of interface card
= Current IP Address of port
LD6 Operation
59(85)