Satellite Constellations - Veripos LD6 Operation Manual

Do's and Don'ts for LD6
DO's
•
Do use the Shutdown control (in the Actions menu) for the LD6 BEFORE turning off
the power. Wait until the LD6 screen is blank before disconnecting power.
•
Do take care not to obstruct the side ventilation panels for the fan assisted cooling
tunnel.
•
Do only use VERIPOS supplied crossover cable adapters for input / outputs. This is
especially important for serial RS232/422 use where different RJ45 to D9 adapters
are used.
•
Do only connect the LAN Crossover network adapter to an LD6 LAN port. The
adapter wiring is not compatible with serial COM ports.
DON'Ts
•
Do not load software onto the LD6 not issued from VERIPOS e.g. as part of the LD6
build. Doing so could seriously compromise system performance.
•
Do not insert USB memory device unless first scanned with up to date virus scanning
software
•
Do not activate the pin reset buttons on the rear of the unit unless directed by a
VERIPOS representative
•
Do not remove the QC dongle when using the LD6 in QC mode.
•
Do not use a pen or any other sharp object to operate the touch screen as this could
cause damage.

2.2 Satellite constellations

When specifying the LD6, users choose which satellite constellations are used by
the GNSS receiver card.
The internal GNSS card is preconfigured to the use either GPS or GPS+GLONASS
satellite constellations.
LD6 (Version 8 & Version 50) Operations Manual
LD6 Operation
13(85)