Ld6 Operation - Veripos LD6 Operation Manual

2

LD6 Operation

The controls for working with the LD6 are all available on the touch screen front panel.
Use the LD6 touch screen to configure the unit.
It has a home or main screen display.
The LD6 Integrated Mobile Unit (IMU) is used offshore on vessels to provide high
precision Satellite Positioning Services from VERIPOS.
The LD6 can optionally be equipped to run Verify QC software or the Orion DP software.
It can be fitted with modules to receive the following;
•
GNSS satellite positioning data
•
L-Band satellite positioning augmentation data from geostationary satellite
transmissions
•
Optional MF Beacon position augmentation data
•
Optional UHF position augmentation data
Only one GNSS receiver card may be fitted to the LD6.
The LD6 must have at least 2Gb RAM installed before use with Verify QC on - board.
The LD6 unit supports all VERIPOS position augmentation data services.
Up to three simultaneous position solutions can be calculated (depending on VERIPOS
services enabled). One of these may be a Precise Point Positioning (PPP) solution.
The LD6 supports switching between high accuracy PPP solutions (subject to settling
before position is output).
LD6 (Version 8 & Version 50) Operations Manual
Description
NOTE
Figure 1 LD6 IMU
LD6 Operation
10(85)