Custom Entry Of User Beam Frequency; Enable For Veripos Corrections - Veripos LD6 Operation Manual

Confirm 'Frame Sync', 'Signal Lock' and beam settings for the selected beam.
For reliable operation the SS values should be ≥ 38.0dB/Hz.
2.5.3

Custom Entry of User Beam Frequency

User Beams should only be selected under direction from VERIPOS.
User Beams are not used during normal LD6 operation. Custom entry of a user Beam is
provided to allow the user to manually configure a Beam frequency and bit rate for
reception of Veripos L-Band corrections.
Full instructions regarding User Beam entry can be found in Section 5.4 of this manual.
2.5.4

Enable for VERIPOS corrections

Tel. +44 1224 965900
Go to the LD6 Access Code page LBAND/ Access Info
Contact the VERIPOS Helpdesk to request the unit is enabled and quote:
•
Unit ID
•
Service Access Licence (SAL) number.
•
Provide details of the type of Service(s) you require, e.g. Standard, Standard²,
Ultra, Apex and Orion
Only when the L-Band receiver gets sync with a beam will it display access code
information or allow you to enable/disable the unit.
The Helpdesk will enable the services for the LD6 over the air.
LD6 (Version 8 & Version 50) Operations Manual
NOTE
Email: helpdesk@veripos.com
LD6 Operation
21(85)