Gnss Receiver Config And Status; Antenna Voltage - Veripos LD6 Operation Manual

2.6 GNSS Receiver Config and Status

The LD6 GNSS screen controls power to the GNSS Antenna, shows GNSS
receiver status information and provides access to configuration settings all from
Home/ GNSS.
Options include the ability to monitor and make changes to GNSS receiver:
•
Status – view module info, the current status of position outputs and SV's
used by the GNSS card
•
Config – edit PPS settings on the GNSS card
•
Antenna voltage – toggle antenna power on or off to the GNSS antenna
•
Module Reboot – to be used only under instruction from or by a VERIPOS
engineer
•
Factory Reset – to be used only under instruction from or by a VERIPOS
engineer
•
Hints – advice where available
2.6.1

Antenna Voltage

Antenna power must be toggled On (Home/ GNSS/ Antenna is off) when the GNSS
card is directly connected to a GNSS antenna. The Antenna power should be toggled
off where the LD6 is connected to a powered signal splitter or other external equipment.
LD6 (Version 8 & Version 50) Operations Manual
LD6 Operation
25(85)