Veripos LD6 Operation Manual page 53

LD6 Operation
COM ports 8 – 14 are not configured by default.
VERIPOS recommend using the default port settings wherever practical.
Changes to default port settings should be recorded so that they may easily be re-instated
if it becomes necessary to replace a unit or perform a factory reset.
COM6 and COM7 are configured when the associated receiver modules (MF and UHF)
are installed.
2.11.3.1 LD6 Default COM Port Settings
COM1 – LBAND RTCMa Output – Veripos Corrections
The LBAND - RTCMa output is typically used to provide corrections to Verify QC or other
VERIPOS Equipment.
.
The same RTCM data is supplied to the LD6 internal calculations
Veripos recommend that all reference stations are enabled on RTCMa.
All Veripos algorithms are designed to automatically select the optimum stations for use in
the calculation.
COM2 – NMEA Solution 1 Position Output
Solution 1 is the primary NMEA position output and is used to provide position data to the
users' equipment.
The choice of calculations and the NMEA messages are configured using the NMEA
menu which is accessed via the Solutions button on the Home page. By default, the
"Best" calculation and NMEA GGA message are configured.
COM3 – Raw GNSS Output – Verify QC
The GNSS – Raw output is reserved for use with Verify QC.
It should not be used for any other purpose without first consulting the VERIPOS
Helpdesk.
NOTE
The baud rate may not be reduced below 57600 baud – lower settings result in data
loss.
For long cable runs, it is preferable to use a LAN interface or RS422 rather than RS232.
LD6 (Version 8 & Version 50) Operations Manual
52(85)