Honda CRF450R 2009 Service Manual page 482

REAR WHEEUSUSPENSION
15-42
ASSEMBLY
Apply specified grease (page 1-21) to a new dust seal
lips and side collars.
DUST SEALS
• Make sure the needle bearing rollers are in position
before installing .
.-a
~
Number of needle rollers:
Shock link side: 32
Swingarm side: 32
Shock absorber side: 27
Inslallthe washers and dust seals (shock link side).
InsleUthe dust seals to the shock arm (swingarm side).
Install the pivot collar, side collars and dust seals
(shock absorber side).
Install the side collars with there larger 0 .0 . side
facing out.
Install each dust seal with their marked side facing
oul.
SIDE COLLARS ..
~
PIVOT
Apply specified grease (page 1-21) to the side collar c- s - ' o -E- C - O - L -LA - R- s - - - - - -p - '- V- O - T-C -O -L-LA - R - s - ,
inside surfaces.
Inslall the pivot collars and side collars to the shock arm ..
~
0i ?
(swingarm side, shock link side).
The shock link side pivot coliar is longer than the
swingarm side pivot collar.
Q
SHOCK ARM
Apply specified grease (page 1·21) to new dust seal lips
:= ~ =::-: ===O=U=S = T== S = E A = L = =========~
and side collars.
""~
Install the dust seals. pivot collar and side collars.
rId!
• Make sure the needle bearing rollers are in position ........
before installing.
Number of needle rollers: 32
Inslall the dust seals with the marking side fadng
oul.
INSTALLATION
Apply molybdenum oil solution to the shock. link and
shock arm nut threads and seating surface.
Loosely install the following:
- Shock link
- Shock link boltJnuVwasher (frame side)
- Shock arm
- Shock arm boltJnuVwasher (swingarm side)
- Shock arm boltJnut/washer (shock link side)
- Shock absorber lower mounting bolt/nut
(page 15-38)
Tighten Ihe all nuts 10 the specified torque.
PIVOT COLLAR
o
""
SIDE COLLAR ...
~