Honda CRF450R 2009 Service Manual page 504

HYDRAULIC BRAKE
Apply silicone grease to the contact area of the push
rod and brake lever adjusting bolt tip.
NOielhadirectionof
Inslallths push rod to the hollow of the master piston
the push rod. securely.
Make sure the tab Inslalithe brake lever assembly while aligning the push
on
lhe push rod is rod end with the knocker arm.
seated on the boot.
Set
the boot to the knocker arm groove securely.
MASTER PISTON
PUSH ROD
BRAKE lEVER
ASSEMBLY
Apply silicone grease to the spring both ends, and
:==================~
install it between the master cylinder and brake lever BRAKE LEVER ASSEMBLY
16·18
assembly.
Apply silicone grease to the pivot bolt sliding surface.
Install and lighten the pivot boll to the specified torque.
TORQUE : 1.0 N'm (0.1 kgf'm ,
O.71bHt)
Tighten the pivot nul to the specified torque while
holding the pivot bolt.
TORQUE : S.9 N'm (0.6 kgf·m, 4.4IbHt)
Check the brake lever for smooth operation.
Install the dust cover.
MASTER
DUST COVER PIVOT BOLT
~
PIVOT NUT