Configuring Alarms; Figure 3-46 Auto Register Configuration Interface - Honeywell HEN04111 User Manual

90 | Embedded Network Video Recorder User Guide
2.
3.
4.
5.
6.

Configuring Alarms

Click the Alarms icon
www.honeywell.com/security
Figure 3-46 Auto Register Configuration Interface
Note Do not enter a TCP port number for the network default port.
Click to Enable automatic registration to the proxy server.
Open the proxy server software that was developed from the SDK, then enter the global
setup.
Ensure that the auto connection port here is the same as the port you set in
Add the device. Do not enter the default port number such as the TCP port in the mapping
port number. The device ID should be the same as the ID you entered in
Click Save to complete the setup.
Boot up the proxy server. If you see that the network status is Y, then you correctly
registered your device. You will be able to see the proxy server when the device is online.
Note The server IP address can also be the domain. However, you need to register the
domain name before you can run the proxy device server.
in the Setting interface to open the Alarms configuration interface.
step 2.
Figure 3-46.