Dismantling And Disposal; Safety Instructions For Dismantling And Disposal; Dismantling - CNC-Step T-Rex Servo Series Operating Instructions Manual

Disma ntling and disposa l
11
After the end of use of the machine has been reached, the machine must be dismantled and disposed
of in an environmentally friendly manner.
• Dismantling may only be carried out by specially trained specialist personnel.
• Work on the electrical system may only be carried out by electricians.
1 1 .1 S a f e t y i n s t r u c t i o n s f o r d i s ma n t l i n g a n d d i s p o s a l
Improper disassembly
WARNING:
Risk of injury in case of improper disassembly!
Stored residual energies, angular components, tips and corners on or
in the machine or on the required tools can cause injuries.
• Ensure sufficient space before the start of the work.
• Handle open sharp-edged components carefully.
• Pay attention to order and cleanliness at the workplace!
Components and tools lying loosely on top of each other or
around are sources of accidents.
• Professionally dismantle components. Pay attention to the
sometimes high dead weight of the components. If necessary,
use hoists.
• Secure components so that they do not fall down or fall over.
• In case of ambiguity, consult the manufacturer.
1 1 .2 D i s ma n t l i n g
Before disassembly begins:
• Switch off the machine and secure it against reactivation.
• Physically separate the entire power supply from the machine, discharge stored
residual energy.
• Remove operating and auxiliary materials as well as other processing materials
and dispose of them in an environmentally friendly manner.
Subsequently, assemblies and components are professionally cleaned and dismantled in compliance
with applicable local occupational health and safety and environmental protection regulations.
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Support: +49 (0)2831/91021-50
Operating instructions
T-Rex Servo-Series
Page 87
23.09.2020