Malfunctions; Safety Instructions For Troubleshooting - CNC-Step T-Rex Servo Series Operating Instructions Manual

M alfunctions
9
The following chapter describes possible causes of malfunctions and the work to eliminate
them. In the event of an increased malfunction, shorten the maintenance intervals
according to the actual load. In the event of malfunctions that cannot be remedied by the
following information, contact the support/service of the manufacturer.
9 .1 S a f e t y i n s t r u c t i o n s f o r t r o u b l e s h o o t i n g
Electrical system
DANGER:
Danger to life due to electric current!
In case of contact with live components, there is a danger to life.
Switched on electrical components can perform uncontrolled
movements and lead to the most serious injuries.
Before starting the work, switch off the electrical supply and
secure it against reactivation.
Moving components
WARNING:
Risk of injury due to moving components!
Rotating and/or linearly moving components can cause serious injuries.
• Before all work to eliminate faults on moving parts, switch off the
machine and secure it against reactivation. Wait until all
components have come to a standstill.
• Wear tight-fitting protective workwear with low tensile strength in
the hazardous area.
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Support: +49 (0)2831/91021-50
Operating instructions
T-Rex Servo-Series
Page 77
23.09.2020