S2C228: Programming Pendant Cycle Switching; S2C229: Servo On From External Pp Prohibition; S2C230: Programming Pendant Operation When "Io" Is Selected For Remote Mode - YASKAWA DX100 Operator's Manual

DX100

8.3.0.26 S2C228: PROGRAMMING PENDANT CYCLE SWITCHING

8.3.0.27 S2C229: SERVO ON FROM EXTERNAL PP PROHIBITION

8.3.0.28 S2C230: PROGRAMMING PENDANT OPERATION WHEN "IO" IS SELECTED FOR
REMOTE MODE
8 Parameter
8.3 Mode Operation Setting Parameters
This parameter specifies whether cycle switching from the programming
pendant is accepted or not. The specification can be done on the
OPERATING CONDITION window.
0 : Permitted
1 : Prohibited
This parameter specifies whether a servo ON instruction is accepted or
not. More than one instruction can be specified. For example, to permit
the servo ON instruction from an external input only, set "2." In this case,
servo ON instruction from the programming pendant is not accepted. The
specification can be done on the OPERATING CONDITION window.
This parameter specifies whether each operation of the following is valid
when "IO" is selected for remote function selection. IO and command are
available for remote function selection: "IO" is set prior to shipping.
"Command" is valid when transmission function (optional) is specified.
工控帮助教小舒QQ:2823408167
8-18
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/