Table of Contents
Advertisement
MF5 Service Manual
________________________________________________________________________________________________________________
3 Disassembly & Reassembly Procedures
a.
This section describes the procedures required to exchange parts and conduct repairs.
Whenever a part or sub assembly is replaced, mechanical and functional testing as described in
Section
Mechanical & Functional Testing
b.
The MF5 can be repaired and maintained with standard tools. No special tools are required.
The following tools may be required to service and support the MF5:
•
Hex key driver (Allen key) 3mm
•
Hex key driver (Allen key) 2.5mm
•
Hex key driver (Allen key) 2mm
•
Hex key driver (Allen key) 1.5mm
•
Torx driver T20
•
Torx driver T10
•
Spanner 18mm
•
Spanner 13mm
•
Spanner 10mm
•
Pin punch 3mm
•
Silicon Grease, Molykote 111 Compound
•
Silicon Rubber Flowable Non-Corrosive, Dowsil 3140 RTV Coating.
•
Threadlocker, Low strength (all metal) Loctite 222
must be completed.
14
Advertisement
Table of Contents
