Open The Detector Chassis - Minelab MF5 Service Manual

_________________________________________________________________________________________________________________

3.1 Open the Detector Chassis

a. In order to conduct repairs and replace many of the parts of this detector, the first step
will often be to open the detector chassis. Many sections of this manual will refer to this section.
b. Required Tools
The following tools are required to open the detector chassis:
•
Hex key driver (Allen key) 3mm
•
Torx driver T20
c. The following procedure outlines the steps involved in opening the detector chassis:
•
Prepare a clean well-lit workspace.
•
Turn the detector off and remove the batteries.
•
Remove the four (4) Screws from the top of the armrest and remove the armrest.
•
Place the detector on its right side with the ON/OFF switch uppermost and remove the two
(2) Screws (M4x45mm) that secure the Cover Cable.
•
Remove the Cover Cable.
Figure 7: Remove Armrest.
15
MF5 Service Manual