MF5 Service Manual
________________________________________________________________________________________________________________
3.5.2 Remove the Shafts
a.
Required Tools:
•
Flat tip screw driver.
b.
To remove the shafts from the detector firstly open the detector chassis as described in
Section
Open the Detector
•
Lift the shafts clear of the detector.
•
Remove the Pin Coil Cable from the upper end of the upper shaft. Turn the Pin Coil Cable
clockwise (to unlock) and then lift out.
•
Remove the two (2) Screws (Nylon M6x14) from the Cap Shaft on the lower shaft.
•
Insert a flat tip screwdriver into the slot underneath the Cap Shaft and lift and remove the
Cap Shaft.
Chassis. Once completed:
Figure 72: Shaft and Coil Removed from Detector
Unlock
Figure 73: Remove Pin Coil Cable.
56