Table of Contents
Advertisement
MF5 Service Manual
_________________________________________________________________________________________________________________
•
Slide the coil out and off the lower shaft, exposing the coil cable. Feed the coil cable
connector into the upper shaft and pull the coil cable out of the end of the lower shaft.
c.
The Shafts have now been removed from the MF5.
3.5.3 Attach the Shafts
a.
The detector chassis needs to be opened in order to fit the shafts to the detector, refer to
Section
Open the Detector Chassis
b.
The coil must be connected to the shaft then the shaft connected to the detector this
process is described in Section
c.
Assemble the detector as described in Section
d.
Once the detector is fully assembled check the operation of all moving parts and test the
detector as described in Section
Figure74: Remove Cap Shaft.
Figure 75 Remove Coil Cable from Shafts
.
.
Connect the Coil
Mechanical & Functional Testing
57
Close the Detector
Chassis.
.
Advertisement
Table of Contents
