MF5 Service Manual
________________________________________________________________________________________________________________
Coil Transmitter
connector
Figure 34: Unplug Coil Transmitter and Receiver Connectors from the Main PCB
•
Remove the three screws that hold the main PCB in place.
•
Slide the main PCB away from the battery assembly until the ends of the main PCB
disengage from the slots in the detector body near the battery compartment.
•
Gently tilt the top side (near the detector handle) of the main PCB up and away from the
housing and lift the main PCB from the detector body.
The Main PCB has now been removed from the metal detector and can be replaced if
c.
required.
Figure 35: Remove main PCB mounting screws (3).
Coil Receiver
connector
32