Minelab MF5 Service Manual page 79

MF5 Service Manual
_________________________________________________________________________________________________________________
4. Screw, 3.5x20
Torx T10
•
Unplug the Vibration Motor from the connector on the Main PCB.
•
Remove the Screw 3.5x20 (Torx T10) from the clamp then remove the clamp.
•
The Vibration Motor can now be lifted out of the detector chassis.
c. Having removed the Vibration Motor, it can now be replaced, if required.
d. Replace the Vibration Motor by reversing the steps to remove the Vibration Motor.
Figure 101: Vibration Motor Parts
Figure 102: Remove Vibration Motor
79
2. Vibration
Motor
3. Clamp
Vibration Motor
Connector
Vibration Motor
Vibration
Motor