Minelab MF5 Service Manual page 21

MF5 Service Manual
_________________________________________________________________________________________________________________
•
Carefully turn the detector over so that it is on its right side. Check the coil connector nut
is tight.
•
Attach the coil connector to the socket and tighten the coil connector as tight as possible
with fingers.
•
Fit the coil cable into the cable router and check that the loop of coil cable within the shaft
hinge is positioned so that it will not be trapped when the detector chassis is closed.
•
Turn the detector over so it is on its left side.
•
Check the detector handle and armrest slide are correctly positioned on the detector, they
must slide freely along the rod. The holes in the rod must align with the holes in the
detector chassis.
•
Check that the Latch Assembly and Spring Latch Hinge are correctly positioned into the left
side of the detector body with the latch connected to the spring.
Armrest Slide
Rod
Coil Connector Nut
Figure 17: Connect Coil Cable.
Figure 18: Open Detector Chassis
21
Spring connected to latch