Minelab MF5 Service Manual page 36

MF5 Service Manual
________________________________________________________________________________________________________________
•
Connect the Coil Receiver Connector to the Main PCB. Screw the Coil Receiver Connector
to the Main PCB using the M2x5mm screw (31-22005-980). Apply a small amount of
threadlocker (Loctite 222) to the thread of the M2x5mm screw
Coil Transmitter
connector
•
Connect the Wiring Loom Earset to the Main PCB.
•
Connect the Wiring Loom Handle to the Main PCB.
•
Connect the Vibration Motor to the Main PCB.
•
Connect the Connector Coil Loom to the Main PCB.
Figure 40: Connect Coil Transmitter and Coil Receiver.
Figure 41: Connect Earset Loom.
Coil Receiver
connector
36