Minelab MF5 Service Manual page 47

_________________________________________________________________________________________________________________
•
Feed the Pivot Coil Yoke onto the coil cable and carefully move the Pivot Coil Yoke along
the coil cable to the coil. Do not attach the Pivot Coil Yoke to the coil yet.
•
Insert the Pin Coil Pivot into the Pivot Coil Yoke.
•
Wind the coil cable around the pin so that five (5) windings of cable are on the pin in the
Coil Pivot assembly.
•
Feed the Pivot Lower Shaft onto the coil cable.
•
Align the Pivot Lower Shaft so that it is 90 degrees to the Coil and Pivot Lower Shaft.
•
Push the Pivot Lower Shaft into the Pivot Coil Yoke.
Figure 58: Attach Pivot Coil Yoke
Figure 59: Wind coil cable around pin 5 times
47
MF5 Service Manual