Minelab MF5 Service Manual page 44

MF5 Service Manual
_________________________________________________________________________________________________________________
•
Separate the pivot lower shaft from the pivot coil yoke. Gently feed the coil cable through
the pivot lower shaft removing the pivot shaft from the coil cable. Do not over stretch the
coil cable.
•
Pull the Pivot Coil Yoke off the coil and carefully thread the coil cable through the Pivot Coil
Yoke. If required remove the O-ring from the coil. Removing the Pivot Coil Yoke from the
coil may cause damage to the O ring. A flat tip screw driver can be used to prise apart
(expand the diameter ) the Pivot Coil Yoke enough to fit over the O ring as it is removed .
Fig 54: Remove Pivot Lower
Shaft
O ring
Fig 55: Remove Pivot Coil Yoke
44