Minelab MF5 Service Manual page 55

MF5 Service Manual
_________________________________________________________________________________________________________________
•
Once the Pin Camlock Lever has been removed the Pressure Block Camlock can be removed
and replaced if needed.
When the camlocks are closed they must hold the shafts firmly with no slippage. If the camlock
does not hold the shafts firmly in place, then pressure blocks should be replaced.
c. To reassemble the camlock, attach the Pressure Block Camlock to the Camlock Lever.
•
Place the Camlock Lever with Pressure Block Camlock into position within the camlock body
(Camlock Lever open) then insert the camlock pin into place.
NOTE
Figure 71: Insert Pin Camlock Lever.
55