Removing The Handle - Minelab MF5 Service Manual

_________________________________________________________________________________________________________________

3.6.1 Removing the Handle

a. No tools required to remove the handle once the detector chassis is opened.
d. The detector body must first be opened to remove the handle as described in Section
the Detector Chassis
•
Disconnect the Wiring Loom Handle. Hold one side of the connector firm against the
detector body whilst gently pulling the other side.
•
Disconnect the spring latch hinge from the Latch Assembly.
•
Lift the handle off the Pin Handle Pivot.
•
Remove the Rod Handle Slide from the handle.
Figure 77: Disconnect Wiring Loom Handle
59
MF5 Service Manual
Open