Minelab MF5 Service Manual page 61

_________________________________________________________________________________________________________________
•
Thread the Wiring Loom Handle into the detector body.
•
Push the handle onto the Pin Handle Pivot.
•
Connect the Spring Latch Hinge to the Latch Assembly.
•
Feed the rod handle slide through the handle (and Armrest Slide Assembly) and into
position.
•
Connect the Handle to the Wiring Loom Handle, use a small amount of Silicon Grease on
this round connector to the handle. Locate the cables into the cable router.
Pin Handle Pivot
Figure 79: Thread the Wiring Loom Handle
Figure 80: Latch Hinge and Spring Latch Hinge
61
Spring Latch Hinge
Latch Assembly
MF5 Service Manual