Minelab MF5 Service Manual page 77

_________________________________________________________________________________________________________________
b. Required tools:
•
Screw driver flat tip.
•
Silicon Grease
c. Open the detector body as described in Section
the Wiring Loom Handle as follows:
•
Disconnect the Wiring Loom Handle socket from the plug (handle wiring loom).
•
Disconnect the Wiring Loom Handle from the main PCB.
•
Remove the Clip External 7mm from the Wiring Loom Handle at the entry point to the
detector chassis.
•
Thread the wiring loom handle out of the detector chassis
O ring BS012
d. The Wiring Loom Handle can now be removed and replaced. To fit the Wiring Loom Handle
follow the removal instruction above in reverse order.
e. Apply a small amount of silicon grease to the round handle plug before connecting also
make sure the O ring is clean and lightly greased. Then assemble the detector as described in
Section Close the Detector Chassis
Open the Detector
Unplug from PCB
Remove E clip
Unplug handle
Figure 98: Wiring Loom Handle
Figure 99: Wiring loom Handle
77
MF5 Service Manual
Chassis. Then remove
Circlip External