Minelab MF5 Service Manual page 71

_________________________________________________________________________________________________________________
•
Lay the detector body on its right side with the Switch Sensitivity facing upwards. Set the
Switch Sensitivity control to 3 IED.
•
Using a 2mm hex key driver (allen key), undo the screw in the centre of the Switch
Sensitivity and remove the screw, bush, spring and knob from the switch.
•
Use a 10mm spanner to remove the nut and locking washer from the Switch Sensitivity.
Connector
Sensitivity Switch
Sensitivity Switch
Figure 90: Sensitivity switch connector
71
MF5 Service Manual
Locked
Locking bail Open
Unplugged