Minelab MF5 Service Manual page 25

_________________________________________________________________________________________________________________
•
Place the detector on its right side. Remove the Cover Cable then insert and tighten the
two (2) screws (M4x35mm) into the shaft hinge.
•
Confirm coil connector is tight by turning the knurled connector collar as tight as possible
by hand (clockwise no tools). Check the connector 18mm lock nut is tight then locate cables
into the cable router.
•
Attach the Cover Cable and make sure the protrusion on the underside of the hinge cover
engages into the slot on the detector body near the hinge. Fit the two (2) screws
(M4x45mm) into the Cover Cable and tighten.
Figure 24: Insert two (2) screws (35mm length)
25
MF5 Service Manual