Close The Detector Chassis - Minelab MF5 Service Manual

MF5 Service Manual
________________________________________________________________________________________________________________

3.2 Close the Detector Chassis

a. Required Tools.
•
Hex key driver (Allen key) 3mm
•
Torx driver T20
•
Silicon Grease
b. The following procedure outlines the steps involved in closing and resealing the detector
chassis:
•
Ensure all parts are present, in good working order and lay the detector chassis on its left
side.
•
Thread the coil cable through the detector hinge and position the upper shaft into the
detector body.
Figure 15: Open Detector Chassis
Figure 16: Attach Shafts
20