Minelab MF5 Service Manual page 67

_________________________________________________________________________________________________________________
•
Slide the battery compartment rearward (away from the main PCB), threading the battery
connector out of the detector body.
•
Check that the Battery Compartment has an O ring positioned where the battery cables
leave the battery compartment and entre the detectors sealed enclosure.
•
Close the Battery Lid.
•
Install the Battery Compartment by first feeding the battery connector through the hole in
the detector body.
•
Slide the Battery Compartment into position.
•
Connect the battery connector.
•
Insert the two (2) mounting screws (12mm).
b. Reassemble the detector by closing the detector chassis as described in Section
Detector Chassis.
Battery Connector
Figure 86: Replace Battery Compartment
67
MF5 Service Manual
Close the