Remove The Coil - Minelab MF5 Service Manual

_________________________________________________________________________________________________________________

3.4.1 Remove the Coil

a. Required Tools:
•
Hex key driver (Allen key) 3mm
•
Flat tip screw driver
b. To remove the Coil from the MF5:
•
Prepare a clean well lit area in which to work.
•
Switch off the detector and remove the batteries.
•
Place the detector on its right side and remove the two (2) screws (M4x45mm) that secure
the Cover Cable.
•
Remove the Cover Cable.
•
Unscrew and disconnect the coil connector.
Coil Connector
Figure 45: Remove Cover Cable.
Figure 46: Disconnect the coil.
39
MF5 Service Manual