Minelab MF5 Service Manual page 41

_________________________________________________________________________________________________________________
•
Slide the coil out and off the lower shaft, exposing the coil cable.
•
Push the coil cable connector into the shaft hinge whilst gently pulling the coil cable out of
the end of the lower shaft. Once the coil connector has passed through the shaft hinge it
should slide out easily from the shafts. Do not force the coil cable or coil connector.
The coil can now be removed or replaced as required. To fit the Coil to the detector, refer
c.
to section Connect the Coil.
Figure 49: Slide the Coil off the Shaft
Figure 50: Coil removed from detector.
41
MF5 Service Manual