Minelab MF5 Service Manual page 51

_________________________________________________________________________________________________________________
•
Push the Pin Coil Cable into the shaft and inside the spirals of the coil cable. Turn the pin
counter clockwise to lock it into place.
Locked
•
Attach the Cover Shaft Hinge to the shaft and screw into place.
•
Attach the Cap Shaft to the lower shaft then insert the two (2) Screws (M6x14mm Nylon).
•
Thread the coil cable through the detector hinge then place the shaft onto the detector
hinge.
Figure 65: Insert Pin Coil Cable.
Figure 66: Attach Cap Shaft
51
MF5 Service Manual
Cable held firm
by pin inside
cable spirals